Easy Load Tray-XL (2 Ramps)

review
4
0
5
Your Price: $1,025.00
Backordered - Ships in about 2-3 Weeks
Part Number:BIC-1-1-0-1-ELTXL-0818
Easy Load Tray-XL (Two Ramps)


Introducing Easy Load’s newest product, an outside the vehicle carry tray for your recumbent trike or handcycle. The Easy Load Tray uses Easy Load's same unique answer to avoid lifting when loading a trike or handcycle, 4’ ramps which easily attach to the tray for loading and then stow on the tray when not in use. There is an option for a third ramp for those who wish to load the single wheel of a trike or handcycle first. The ramps may be used from either side of the tray.
The Easy Load Tray uses the transporting vehicle’s 2” receiver hitch. It lays out flat to load your trike or handcycle from either side with two ramps. Three ramps are available if desired. There are two wheel chocks on the outside wheel trays and tie down straps on all three wheel trays. It folds vertically when unloaded therefore it is not required to remove the Tray when the trike or handcycle is not loaded. The three wheel trays are adjustable on the frame to accommodate handcycles and longer recumbent trikes. The wheel channels and ramps are 2.75 inches wide. The Easy Load Tray's unique receiver hitch insert allows the tray, when empty, to be raised to an upright locked position. Each system comes with reflective red and silver safety tape for extra visibility for following drivers and tail lights featuring turn signals, brake lights and running lights. To save shipping costs some assembly is required.

The Easy Load Tray-XL is 6” longer front to back than the standard Easy Load Tray to accommodate wider track trikes and weighs approximately 38 pounds. The Wheel Channels and Ramps are 5” wider for 7.75" of width to accommodate Fat Tires. Otherwise, the two products are functionally the same.

Note: The bottom of the 2" receiver hitch must be at least 16" above the ground. If it is not, a riser will be required. We can provide a recommendation for the appropriate riser.

If a riser is required for the transporting vehicle to assure the 16" hitch clearance required by Easy Load, a smaller Hitch Tite is required for the riser shaft where it connects to the trike transporting vehicle. Click here for Small Hitch Tite.

IMPORTANT NOTICE: Please be sure to email or call us prior to placing your order to ensure that your vehicle can properly secure an Easy Load Tray. A $50 cancellation fee will be applied to your refund upon order cancellation. Bend It Cycling will contact you regarding shipping costs after order is placed. Depending on your delivery address, Shipping costs typically range between $75 and $105 for orders shipped within the US.
4 Stars
None
Instructions needed diagrams. My trike was an exact fit at narrowest track settings, might be a problem for a narrower trike. Ordered extra ramp, but no extra storage Velcro was included. Ideally cotter pins should have had handles and safety wires. I only mention all this because of the high price.
Did you find this helpful?  7 of 7 Found Helpful
Reviewed by:  from Tn. on 6/12/2019
4
5 Stars
Ms
Seems like a great product. Got it assembled without issues. Don't have bike yet so cant review that part yet.
Did you find this helpful?  2 of 6 Found Helpful
Reviewed by:  from Minnetonka. on 5/1/2019
5

Related Items